Hx8872c Datasheet -

Whether you are a firmware engineer debugging a black screen or a hardware designer laying out a 6-layer PCB, the HX8872C datasheet is your ultimate reference. Keep it open, use the search function liberally, and when in doubt, trust the electrical tables over online forum advice.

The HX8872-C is a high-performance, highly integrated timing controller (TCON) designed primarily for small-to-medium-medium TFT-LCD panels. Manufactured by Himax Technologies, this integrated circuit (IC) acts as the vital bridge between digital video processors and the panel's source and gate drivers.

The HX8872C is excellent for legacy or industrial designs where a parallel MCU interface is preferred, and you need reliable, documented timing. However, for new designs, the ILI9341 or ST7789 have better community support and SPI options.

A unique part of the is the lengthy section on Gamma Correction . Each TFT panel has a non-linear voltage-to-brightness response. The datasheet provides a default gamma table, but manufacturers often provide custom values. If your display shows washed-out colors or poor contrast, the gamma registers (0xE0, 0xE1, etc.) are likely misconfigured. hx8872c datasheet

For detailed pinout diagrams, including pin assignments for power, ground, I/O, clock, and display interface, it is essential to consult the official datasheet for the specific package variant.

The datasheet includes a note: "When switching from RGB mode to SPI mode, a 1ms delay must be inserted after reset." Overlooking such notes is a common root cause of "black screen" issues.

This datasheet provides a generalized overview. For precise specifications, pin configurations, and application information, refer to the official HX8872C datasheet provided by the manufacturer. Whether you are a firmware engineer debugging a

A2: The VDD operating voltage range is 2.0V to 5.5V.

Single-chip audio power amplifier (class AB, low-voltage) Typical use: Portable audio devices, battery-powered speakers, phones, multimedia devices. Package: Commonly available in SOP-8 or MSOP-8 (check supplier). Supply voltage (Vcc): Typical range 2.5 V to 5.5 V (verify with specific vendor datasheet) Output power: Up to ~3 W per channel into 4 Ω at 5 V (single-ended) — actual power depends on supply voltage, load impedance, and THD+N. Quiescent current: Typically low (tens to hundreds of μA in standby; a few mA in active mode) — refer to datasheet section for exact figures. Shutdown/Standby pin: Usually provided to reduce power consumption. Gain: Fixed internally (commonly around 20–30 dB) or set by external resistors depending on variant. Thermal protection: Integrated thermal shutdown and short-circuit protection. Pop-and-click suppression: Soft-start and mute functions included on many revisions. Inputs: Differential or single-ended input pins; input coupling capacitors recommended. Outputs: BTL (bridge-tied load) outputs for speaker driving, may also support single-ended configurations with external components. ESD protection: I/O protection on most commercial samples.

Given the chip's ability to directly drive displays, here are conceptual application scenarios: A unique part of the is the lengthy

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Features low-power standby modes to extend battery life in portable configurations. 2. Pin Configuration and Signal Descriptions

To download the official datasheet, you can try the following:

If you are currently troubleshooting or designing a board with this component, please let me know:

It operates within a standard voltage range (e.g., 2.5V to 3.6V), suitable for many portable and embedded applications.