No Sync Signal Jrc Radar !exclusive! Jun 2026

If the error occurred immediately after a software update, a battery replacement on the board, or a system reset:

Deliverables you can provide next

Radar transceivers use high-voltage components (Magnetron, Modulator). Only qualified marine electronics technicians should perform internal repairs. This guide focuses on troubleshooting external and configurable causes.

Though more directly related to power output than sync signals, magnetron failures can create symptoms that imitate a sync problem. When the magnetron is weak or dead, the display may show no targets despite all sync functions working. Similarly, a defective modulator—such as the CME-307 or CME-308 in JMA-2343 series—can disrupt the transmission and reception sequence. no sync signal jrc radar

Quick troubleshooting flow (concise)

The inter-unit cable is broken or filtering the signal out.

The encoder in the scanner unit might be failing to produce the "Azimuth" (AZI) or "Heading Line" (HL) signals needed for synchronization. Transmitter/Receiver (TX-RX) Board Failure: If the error occurred immediately after a software

The modulator board or the trigger generation circuit is defective and requires repair or replacement.

I can provide the specific wiring pinouts or menu navigation steps for your exact system. Share public link

Do you see or flashing codes on the display? Though more directly related to power output than

Failure in the high-voltage modulator or circuit breakers inside the turning unit will stop pulse generation. 3. Processor / Graphic Board Issues

Is the antenna when you switch the unit to transmit?

Ensure the scanner unit is receiving power. Listen for rotation or humming from the antenna.

A non-rotating antenna often points to worn-out motor carbon brushes, damaged gears, or a blown motor drive relay. 4. Isolate the Processor Circuitry