: Right-click the Start menu and select Device Manager .
If the device connects but fails to read modules, your hardware firmware version may not match your software version. Run the Firmware Update utility embedded within your diagnostic software options while connected to a stable 12V power source.
| Problem | Likely Cause | Solution | |--------|--------------|----------| | Driver installs but interface not found | Wrong COM port selected | Change COM port in Device Manager (Advanced > Port Settings > Advanced > COM Number) | | Error 10 (Device cannot start) | Conflicting drivers (e.g., old Prolific) | Uninstall all USB serial drivers, then clean install FTDI top driver | | Windows says “Driver is not intended for this platform” | 32-bit vs 64-bit mismatch | Download specific 64-bit driver version | | CDP disconnects randomly | Power saving enabled | Go to USB Root Hub properties → Power Management → Uncheck “Allow computer to turn off” | | Yellow bang after Windows update | Driver signature enforcement re-enabled | Re-disable signature enforcement or install a signed top driver |
under "Other devices" or "Universal Serial Bus controllers". Update Driver Right-click the device and select Update driver Browse my computer for driver software Let me pick from a list of available drivers on my computer , then click Path Selection autocom cdp usb drivers download top
| Issue | Likely Cause | Potential Solution | | :--- | :--- | :--- | | | Corrupted driver installation | Manually update the driver; select from list of drivers | | "Unknown USB Device" error | Residual driver registry entries after uninstall | Uninstall drivers; scan registry with CCleaner; reinstall fresh | | Driver conflicts from previous installations | Old driver files or software remain | Use Revo Uninstaller to clean registry; install updates in correct order | | Windows 10 or 11 installation problems | Automatic driver installation disabled | Ensure drivers are not blocked; manually specify folder | | Device recognized but software won't connect | Interface not properly tested in software settings | Run "Hardware Setup" test in software; perform firmware update |
Avoid “driver downloader” sites full of ads and malware. Stick to .
The Autocom CDP (Car Diagnostic Platform) series is a suite of professional automotive diagnostic tools. The CDP+ serves as a communication link between a vehicle's OBD2 port and the diagnostic software on a laptop or PC. : Right-click the Start menu and select Device Manager
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Obtain the full software package from the Autocom official releases page ( https://autocom.se/en/releases ). If the software package is not available directly, third-party drivers from the table above can be used.
Right-click on the problematic device and select . Click on "Browse my computer for drivers" . | Problem | Likely Cause | Solution |
Q: Why do I need to download Autocom CDP USB drivers? A: You may need to download Autocom CDP USB drivers if you have a new computer or operating system, your device is not recognized by your computer, or you have updated your device's software.
Modern Windows operating systems reject drivers without a Microsoft digital signature. To bypass this, restart your PC while holding the Shift key. Go to Troubleshoot > Advanced Options > Startup Settings > Restart . Upon reboot, press F7 to select "Disable driver signature enforcement" . Once booted, install your drivers normally. Firmware Mismatch After Driver Update
: Because Autocom interfaces communicate using a virtual serial bridge, downloading the latest universal FTDI Virtual COM Port (VCP) Drivers directly from the chip manufacturer ensures compatibility with newer operating system kernels like Windows 11.
I understand you're looking for help with USB drivers, likely for professional vehicle diagnostics.